Clarke CMS10S2 Betriebsanleitung PDF herunterladen (Seite 15)

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

PERFORMING A SLIDING CUT

The guide rail allows cutting larger workpieces up to 340 mm x 78 mm using an

out-down-back sliding motion.

1. Release the slide rail lock.

2. Pull the saw head towards you (1)

and switch the saw on as

mentioned on the previous page.

3. Lower the saw blade (2) into the

workpiece and push the head

back (3) to complete the cut.

• Do not perform sliding cuts on

workpieces smaller than 50 x

100 mm.

• Remember to lock the saw

head in the rear position when

the sliding cuts are finished.

MITRE CROSS-CUT

1. Release the table mitre lock and

move the arm left or right to the

required angle.

2. Lock in position by tightening the

table mitre lock.

• Always ensure that the table

mitre lock is securely tightened

before cutting.

• Allow the blade to cut freely.

Do not force the tool.

• Proceed as for a vertical straight cross-cut.

NOTE: When mitering the end of a piece of wood with a small off-cut, position

the wood to ensure that the off-cut is to the side of the blade with the

greater angle to the fence; i.e. left mitre, offcut to the right - right mitre,

off-cut to the left.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Keine Kommentare

Clarke CMS10S2 Betriebsanleitung Seite 15